Quested SB10 Bedienungsanleitung

SB10SB10 User Manual Quested Monitoring Systems Ltd., Units 6-8 Kingsgate, Heathpark Industrial Estate, HONITON, Dev

10 stable imaging and to maximize the area of the “sweet spot”, the axis of the left and right monitors should cross at a point approximatel

11 25 o120cmS6S6SB1040cmSpeaker directed at a pointapproximately 40cm behindlistening positionDiagram shows asymetric room layout. The system is not

12 A final alignment should be executed when the exact position of the monitoring has been determined and any furniture, soft furnishings an

13 You now need to obtain maximum output of the speaker combination at the crossover point by means of the phase potentiometer and pol

14 FILTERS Left & right input summed to sub output Subsonic/High pass: -3dB @ 14Hz, 24dB/oct or -3dB @ 28Hz, 24dB/oct (set by interna

15 127mmor 5"127mmor 5"69,50mmor 2.75"69,50mmor 2.75"290332,0mm617.0mmCLCL332.0mmFixing points forfeet or spikesFixing points for

16 10 APPENDIX 10.1 Accessori es Omnimount ™ plus fixings Quested S series stands (with unique coupling system) 10.2 Spares Des

2 CONTENTS 1 Introduction 3 2 Safety Considerations 3 2.1 General 3 2.2 Hearing

3 Thank you for purchasing this Quested monitor. You can be certain that you have purchased one of the finest monitors in the world. If you ta

4 The wire, which is coloured brown, must be connected to the terminal in the plug which is marked with the letter ‘L’ or coloured red.

5 4.2 Stand Mounting The SB10 has built-in mounting points that are located on two of the sides of the cabinet and are for use with the

6 115V230V Exploded view of PCB vi ewed from above showing the voltage s el ection connectors with alternative pins for the 115V and 230V s etting

7 interconnecting cable. This is necessary to ensure proper compliance with European Standards for Electromagnetic Compatibility. Pin 1 carries no si

8 Source Unbalanced Pho no 2 Core cabl e 5 OPERATIONAL CONSIDERATIONS 5.1 Mains O n- Off Switchi ng and Level A rocker switch on the

9 5.8 Polarity This controls the polarity of the sub bass. It is used in conjunction with the phase control to accurat